Инструкция на Контроллеры Hitachi серии PC-P...
Контроллеры Hitachi серииPC-P2HTE. Инструкция по установке и эксплуатации.
Смотрите также: Инструкция по установке и эксплуатации →
Загружаем документ…
Текст инструкции
-
INSTALLATION MANUAL FOR PC-P2HTE 1. SAFETY SUMMARY DANGER: WARNING: - DO NOT pour water into the remote controller - DO NOT perform installation work and electrical wiring (hereafter called “controller”). These products are equipped with electrical parts. If poured, it will cause a serious…
-
In case of exposing Remote Control Cable. 1. Fix the holding bracket onto the wall as shown below 2. Attach the stopper to the cable at the inside of the draw-out hole. Band (FieldSupplied) Cable Fix the holding bracket with the mark "↑UP" upward Screw (Accessory) REMOCON A B REMOCON 3. Lead the…
-
Address of Indoor Units: CAUTION: Main unit 1st unit 2nd unit 3rd unit 4th unit 5th unit 6th unit 7th unit 8th unit 9th unit 10th unit 11th unit 12th unit 13th unit 14th unit 15th unit - Use the twist (shield) pair cable (2 x 0.75mm²) as transmitting wire cable for prevention of the malfunction…
-
INSTALATION AND OPERATION MANUAL FOR PC-P2HTE 5.2. SELECTION OF INDOOR UNIT Selection of Indoor Unit for Optional Setting “01” stop flickers. HIGH Select the indoor unit to set by pressing the “” or “” switch and press the “OK” switch. • COOL ADDS. RN A/C HIGH The address of the indoor…
-
Optional Setting Items (Cont.) Individual Setting Availability (A) Code Items C8 Remote Control Thermostat A 00: Not Available 01, 02: *3) C9 Not Prepared - Not Used CA Not Prepared - Not Used Cb Selection of Manual Stoppage Logic N 00: A Contact 01: B Contact CC Not Prepared N 00 d1 Power Supply…
-
5.3.2. INPUT/OUTPUT NUMBER Input/Output Setting Mode (Mode Number “02”) Selection of Input/Output Number HIGH COOL A/C HIGH COOL A/C SERViCE SERViCE Input/Output Number Select the input/output number by pressing the “SELECT” or switch. <Example> When selecting 01 (Output 1) …
-
6.2. SETTING TIMER (PROGRAMMING)
1.Press TIMER switch. SET and SCHEDULE are indicated. Schedule Number “1” flickers and other numbers are indicated. 2.By pressing △schedule switch, schedule Number moves [1]Æ[2]Æ[3]Æ[4]Æ[S]Æ[1]Æ …. *In case of selecting [S], ON/OFF time and shift temperature can be set. *By pressing TIMER switch…
-
INSTALATION AND OPERATION MANUAL FOR PC-P2HTE 6.5. SETTING OF SHIFT TEMPERATURE (ENERGY SAVING MODE) Increase or decrease setting temperature (±3 ºC or ±5 ºC) according to in ON time or OFF time. shift of temperature differs based on the operation mode. In case of “fan”, “cooling” and “dry”, from…
Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.