Инструкции на Контроллеры Hitachi серии PC-P...

Текст инструкции

1. Стр. 1 HANDBOK FÖR INSTALLATION OCH ANVÄNDING

   ÅÃ×ÅÉÑÉÄÉÏÅÃÊÁÔÁÓÔÁÓÇÓÊÁÉËÅÉÔÏÕÑÃÉÁÓ ENGLISH ESPAÑOL MANUAL DE INSTALAÇÄO E DE FUNCIONAMENTO BRUGER- OG MONTERINGSVEJLEDNING INSTALLATIE- EN BEDIENINGSHANDLEIDING SVENSKA Read and understand this manual before using this remote controller. Keep this manual for future reference. Lea atentamente el…

2. Стр. 3 PRECAUCIÓN – Riesgos o prácticas poco seguras que PODRÍAN provocar lesiones

   personales de menor importancia o daños en el producto u otros bienes. VORSICHT – Gefahrenquellen oder leichtfertige Vorgehensweisen, die geringfügige Schäden am Produkt oder an Sachen oder leichte Verletzungen verursachen können. ATTENTION – Utilisation dangereuse ou sans garantie de sécurité qui…

3. Стр. 5

   1. SAFETY SUMMARY Õ DANGER: - DO NOT pour water into the remote controller (hereafter called “controller”). These products are equipped with electrical parts. If poured, it will cause a serious electrical shock. - DO NOT operate switches by wet hand. It may cause an electrical shock. - In case that…

4. Стр. 6 2/2 INSTALLATION WORK

   CAUTION: - DO NOT use the multi-core wire for electrical wiring. If used, some signals of one system transfer to the other system, the signals interfere each other and it cause the malfunction. - DO NOT use thin shield wire such as CPEVS. Such wires with big electrostatic capacity make the…

5. Стр. 7 2.2. BEFORE INSTALLATION

   Check the contents and the number of the accessories in the packing. Remote Control Switch, for Operation Control 2 screws M4x16L For fixing the Holding Bracket onto the wall 1 Band. For fixing Cable to Ring Core Ring Core. 2.3. INSTALLATION SPACE In case of installing the controllers in vertical…

6. Стр. 8 2/4 INSTALLATION WORK

   2. Attach the controller to the holding bracket as follows. „ In case of exposing Remote Control Cable. 1. Fix the holding bracket onto the wall as shown below Fix the holding bracket with the mark "↑UP" upward Screw (Accessory) 2. Attach the stopper to the cable at the inside of the draw-out hole.…

7. Стр. 9

   „ When Using Switch Box. —.Run the cable into Field-Supplied JIS Box (JIS 8336 - 1998) The following 5 types are available. 1. Switch Box for 1 Controller (without Cover) 2. Switch Box for 2 Controllers (without Cover) 3. Switch Box for 1 Controller (with Cover) 4. Switch Box for 2 Controllers (with…

8. Стр. 10 3/6 ELECTRICAL WIRING

   3. ELECTRICAL WIRING 3.1. STANDARD WIRING Band Ring core Ô ATTENTION: - Attach the ring core (black) (accessory) when installing the unit. - Insert the controller cable into the ring core 2 turns as shown in the right figure before connecting to the terminal board. If wiring is 0.75 mm2 is necessary…

9. Стр. 11

   „ Comunication cable shall be Field Supplied. ƒ It should be used twist pair cable 2 x 0,75 mm2 (the max. total length is 500 m). ƒ It can be also used standard shielded cable 2 x 0,75 mm2 connecting the shield to Earth at the electrical box side (the max. total length is 500 m). Solderless terminal…

10. Стр. 12 4/8 CHECKING PROCEDURES

    CAUTION: - In the case that multiple indoor units are controlled simultaneously, set the refrigerant cycle number and the address of Indoor units as indicated below. Address of Indoor Units: Main unit 1 unit st 2 unit nd 3 unit rd 8 unit th 9 unit th 10 unit th 11 unit th 4th unit 5th unit 6th unit…

11. Стр. 13

    5. OPTIONAL SETTING AND INPUT/OUTPUT SETTING OF INDOOR UNIT 5.1. OPTIONAL SETTING MODE Normal Mode (When unit is not operating) —Change to the optional setting mode. Press the “CHECK” switch and the ”RESET” switch simultaneously more than 3 seconds. ˜Selection of Optional Setting Mode SET TEMP °C…

12. Стр. 14 5/10 OPTIONAL SETTING AND INPUT/OUTPUT SETTING OF INDOOR UNIT

    5.3. CHANGING OF OPTIONAL FUNCTIONS AND SETTING CONDITIONS 5.3.1. OPTIONAL SETTING ITEMS „ Optional Setting Mode (Mode Number “01”) š Selection of Optional Setting Items HIGH COOL A/C SERVICE HIGH COOL A/C Item Code of Optional Setting Select the item code by pressing the “TIME” or switch. <Example>…

13. Стр. 15

    „ Optional Setting Items (cont.) (A) Code Items C7 Individual Setting Availability *5) (B) Setting Conditions Cancel of 3 Minutes Compressor OFF Guard A 00: Standard 01: Cancel C8 Remote Control Thermostat A 00: Not Available 01, 02: *2) C9 Not Prepared ― Not Used CA Not Prepared ― Not Used Cb…

14. Стр. 16 5/12 OPTIONAL SETTING AND INPUT/OUTPUT SETTING OF INDOOR UNIT

    5.3.2. INPUT/OUTPUT NUMBER „ Input/Output Setting Mode (Mode Number “02”) š Selection of Input/Output Number 0 HIGH COOL A/C # SERViCE # 3 HIGH COOL A/C # Input/Output Number Select the input/output number by pressing the “TIME” or switch. <Example> When selecting 01 (Output 1) SERViCE # „ Input and…

15. Стр. 18

    PMML0049 A-08/03 Printed in China

Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.