Инструкция на Контроллеры Hitachi серии PC-RLH...
Контроллеры Hitachi серии PC-RLH8/10. Инструкция по монтажу и эксплуатации.
Смотрите также: Инструкция по монтажу и эксплуатации →
Загружаем документ…
Текст инструкции
-
FUNCIONAMENTO BRUGER- OG MONTERINGSVEJLEDNING INSTALLATIE- EN BEDIENINGSHANDLEIDING HANDBOK FÖR INSTALLATION OCH ANVÄNDING ÅÃ×ÅÉÑÉÄÉÏÅÃÊÁÔÁÓÔÁÓÇÓÊÁÉËÅÉÔÏÕÑÃÉÁÓ ENGLISH SVENSKA Do not perform installation work, without referring to our installation manual. No realice la instalación de este equipo…
-
SAFETY SUMMARY Õ DANGER: DO NOT pour water into the remote control switch (hereafter called "controller"). This product is equipped with electrical parts. If poured, it will cause a serious electrical shock. Ô WARNING: DO NOT perform installation work and electrical wiring connection by yourself.…
-
2 OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10
3 INSTALLATION OF WIRELESS RECEIVER KIT CAUTION: Pay attention to the following installation procedures. If not, it may drop from the panel, resulting in a serious accident. PC-RLH8 1) Install the wireless receiver kit, the indoor unit and the air panel at the same time. 2) In case that the…
-
5) Draw out the connecting cable from the wiring hole of the indoor unit, and lead the cable over
the suspension bracket of the indoor unit to the installing position of the receiver kit. Bundle the extra cable with a band. Suspension Bracket 100~200mm Connecting cable Wiring hole of Indoor Unit Connector 6) Install the air panel (option) onto the indoor unit. 7) Attach the receiver kit in the…
-
4 OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10
8) Hook other fixixng nails (3 postions) at square holes of air panel. NOTE: When removing the receiver kit after installing the air panel; Coin or"-" Shaped Driver 1) The corner position of the receiver kit can be lifted when a coin or a “-” shaped driver is inserted into the dent part o and…
-
5) Install the wireless receiver kit to the drain pan
(1) Insert the cable through the hole for wiring. (2) Install the wireless receiver kit completely. Check to nesure that there is no gap between wireless receiver kit and drain pan. Wireless Receiver Kit Enlarged View 6) Lead the cable into the electrical box with other wires. (1) Attach the…
-
6 OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10
7) Remove the cover of indoor unit electrical control box and connect the cable to the terminals A and B of the terminal board (white). NOTE: After connecting the cable, bind up the remaining cable lenght portion by band (Factory-Supplied) and put them in electrical control box. RPC 2.0 to 3.0 HP…
-
OPTIONAL FUNCTIONS 1) Open the lid of case by removing two screws so that the following functions are available. PC-RLH8 Switch "COOL" Switch "HEAT" Remove the screw Dip Switch (SW3; Factory Supplied) Cover Rear Side of Indoor Unit 2) Optional Setting for Dip Switch (SW3) Operation Function…
-
8 OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10
5 OTHERS 1) Proceed the "TEST RUN" mode by using "Operation & Installation Manual" for the wireless remote control switch (PC-LH3A). Turn OFF all power sources before setting the dip switches. 2) Emergency Operation Setting (Refer to the figure of the item 3 "Optional Functions".) In case that…
Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.