Инструкция на Осушители воздуха Sinclair серии CFO-20-40P

Текст инструкции

1. Стр. 1 USER MANUAL

   DEHUMIDIFIERS CFO-20P, CFO-40P

2. Стр. 3 Explanation of Symbols

   DANGER Indicates a hazardous situation that, if not avoided, will result in death or serious injury. WARNING Indicates a hazardous situation that, if not avoided, could result in death or serious injury. CAUTION Indicates a hazardous situation that, if not avoided, may result in minor or moderate…

3. Стр. 4 Appliance filled with flammable gas R290

   Before install and use the appliance, read the owner’s manual first. Before install the appliance, read the installation manual first. Before repair the appliance, read the service manual first. The Refrigerant To realize the function of the air conditioner unit, a special refrigerant circulates in…

4. Стр. 5 Safety Precautions

   ● This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory ormental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards…

5. Стр. 6 Operation Area

   ● This dehumidifier is intended for indoor applications only. It should not be used for commercial or industrial applications. 50cm at least ● During operation, the nearby enclosed space, such as wardrobe can't be dehumidified. temperature will not below 5°C or above 32°C. The suggested range of…

6. Стр. 7 Parts Name

   Front Side Control Panel Air outlet Cover plate (continous drainge) Air inlet Back Side Fixing hole of power cord Water Bucket Power cord 4

7. Стр. 8 Check Before Operation

   aced. Below are the checking steps: 1. Hold the handles on both sides of the water bucket and pull it out following the arrow direction. moved a little after long-time transportation. If it's not placed properly, move it to the correct position by hand. Float Correct Position Wrong Position 3.…

8. Стр. 9 Operation Method

   Dehumidify Mode Timer Indicator Indicator Display Window Wind Direction Indicator Speed Indicator Bucket Full Indicator Water Full Fixed Swing Angle Smart Cont Quiet Dry Wind Direc Mode 5 Filter Clean Filter Cleaning Indicator 6 Timer ON/OFF High Med Low Humidity Timer Fan Notes: ● Water bucker must…

9. Стр. 10 4 Humidity Button

   Press Humidity button to set your required humidity. If hold Humidity button, humidity can be set in 10% increment among 30%-80% circularly. After that, the set humidity will be displayed for 5s. 5 Mode Button Press Mode button can set 4 kinds of dehumidify mode - Smart, Cont., Quiet and Dry. ● If…

10. Стр. 11 Other Instructions

    1. Alarm Warning If the water bucket is full or the water bucket hasn't been put on the correct position for 3mins, the buzzer will give out sound for 10s for reminding you to empty the water bucket or re-install the water bucket at correct position. 2. Auto Stop When bucket is full, remove the unit…

11. Стр. 12 Drainage Method

    Method 1: Drain water through water bucket Notes: ● Do not remove the bucket when unit is in operation or has just stopped. ● Do not use the hose if using water bucket to collect water. When the hose is connected, water will be drained out through it instead of into the bucket. 1. Hold the handles…

12. Стр. 13 Method 2: Drain water through drain hose

    This unit is connect with drain outlet. User can purchase the drain hose whose inner diameter is 14mm (length is 1.3-1.5m) and assemble it on the drain adapter to drain condensate water. When assembling the continuous drain equipment, do turn off the unit and pull out the power plug. 1. Open…

13. Стр. 14 3. Insert the drain hose into drainage adapter to make sure the water won't leak

    out. The horizontal height of drain hose should not be higher than the drain outlet. Do not block the drain outlet to make the condensate water can be drained out smoothly. Please check drainage adapter and drain hose periodically to see whether they are connected tightly and whether they are…

14. Стр. 15 Clean and Maintenance

    Warning: ● Before cleaning, turn off the dehmidifier and disconnect the power. Otherwise, it may lead to electric shock. Otherwise it will damage unit's appearance. . 1. Grille and Case To clean the case: When there is dust on the case, use soft towel to dust it off; When the case is very…

15. Стр. 16 3. Water Bucket

    Every few weeks, clean the bucket to prevent growth of mold, mildew and bacteria. Use soft brush to clean the bucket and then rinse it. CFO-20P 1. Take out the water bucket and then pour out the residual water. 2. Press down 4 buckles around the water bucket. Lift up the drain lid. Buckle Drain Lid…

16. Стр. 17 Check Before Use-season

    ● Check whether air outlet is blocked. ● Check whether power plug and power socket are in good condition. ● Check whether drain hose is damaged. Care After Use-season ● Disconnect power. ● Empty the water bucket. Long-time Storage steps below in order to maintain the unit in good condition. ● Make…

17. Стр. 18 Troubleshooting

    ● Not all the following problems are malfunctions. Problem Possible Causes ● Unit is operating in an area where temperature is higher than 32°C or lower than 5°C. Controls can not be set. ● Bucket is full. ● Noise will rise if compressor has just started. Noise suddenly rises during ● Power supply…

18. Стр. 19

    Problem Possible Causes Solution ● Check if power is lost. If yes, wait for the power to restore. ● If not, check whether the ● Power is not supplied for power circuit or power socket Power indicator is has been damaged. power plug is not well not lit when power ● Check whether power plug is…

19. Стр. 20 Error Codes

    ● Unit's Malfunction Codes No. Display Malfunction Code Unit's Name Display Condition Window Possible Causes ● Ambient temperature sensor is loosen or is poorly connected with the terminal of display board. 1 Ambient Temperature Sensor Malfunction ● Some element of display board may have been put…

20. Стр. 21 No

    Display Malfunction Code Unit's Name Display Condition Window 4 Freon-lacking protection 5 Overload protection 6 Overcurrent protection Possible Causes F0 The compressor ● Refrigerant is leaking. stops. Buttons are ● System is blocked invalid. H3 ● Ambient operation condition is bad. The ● The…

21. Стр. 22 Electric schematic diagram

22. Стр. 23 Producer, service, contact

    Producer: SINCLAIR CORPORATION Ltd., 1-4 Argyll St., London, UK The device was made in China. Service, authorised representative, contact: SINCLAIR Global Group s.r.o. Purkyňova 45 Brno 612 00 Czech republic Tel.: +420 Fax: +420 info@sinclair-solutions.com www.sinclair-solutions.com 20

Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.