Инструкции на Промышленные кондиционеры Sinclair серии SDV5

Текст инструкции

1. Стр. 1 OUTDOOR UNITS SDV5-XXXEAI

   COMMERCIAL AIR CONDITIONERS SDV5

2. Стр. 2 Original instructions

   IMPORTANT NOTE: Read this manual carefully before installing or operating your new air conditioning unit. Make sure to save this manual for future reference.

3. Стр. 4 Ensure the air inlet and outlet are not blocked or performance

   may suffer or it may activate protection, which will stop the unit from running. 3. OPERATION AND PERFORMANCE The cooling and heating operation in a VRF system In extremely strong winds, please prevent the air from flowing backwards into the outdoor unit. ● Each indoor unit can be controlled alone.…

4. Стр. 5

   Explanation of heating operation ● It may take longer to reach the set temperature for general heating operation than for cooling operation. TROUBLES AND CAUSES CAUTION The following operation is performed in order to prevent the heating capacity from dropping or cold air from blowing This unit…

5. Стр. 6

   MALFUNCTION Malfunction display of the outdoor unit’s DSP1 Error code Table.5-1 Error description Remarks E0 Communication error between outdoor units Only displayed on the slave unit with the error E1 Phase sequence error E4 Communication error between indoor and master unit T3/T4 Temp. sensor…

6. Стр. 7

   BUTTON FUNCTION DSP1 SW5 MENU Table 6-1 MENU DSP2 SW4 DOWN SW3 UP SW6 OK 6.1 Button switch function 1) MENU: Long press 5 seconds to enter menu function mode, short press return to the previous menu 2) OK：Short press to enter the next level menu or confirm the selection 3) UP/DOWN： a) Select…

7. Стр. 8 Menu function mode flowchart

   Start Press “menu” Long press “menu” 5 seconds Display “-n1” Press “up” or “down” to choose “X” Display “-nX” Press “menu” Press “OK” to confirm “X” Press “OK” to confirm “Y” Press “menu” Press “menu” Press “up” or “down” to choose “Y” Display “-nXY” Press “OK” to confirm “Y” Press “OK” to confirm…

8. Стр. 9 6.3 System check table

   Press UP/DOWN button to enter system check mode when it is not in menu function mode. DSP1 content Table 6-2 Remarks Parameters displayed on DSP2 0 Unit address 0-2 1 Unit capacity 8-32HP 2 Number of outdoor units 1 3 Number of indoor units as set on PCB 1 4 Total capacity of outdoor unit 2 5 Total…

9. Стр. 10 Available for master unit

   Only available for master unit, displayed on slave units has no sense; 3 Operation mode: 0-OFF; 2-Cooling; 3-Heating;4-Forced cooling 4 Opening angle of EEV: Actual value=Display value*4(480P) or Actual value=Display value*24(3000P) 5 Opening angle of EEV: Actual value=Display value*4(480P) 6 High…

Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.