Инструкция на Промышленные канальные кондиционеры Sinclair серии SDV4

Текст инструкции

1. Стр. 1 FULL DC INVERTER SYSTEMS

   OWNER‘S MANUAL Indoor Units COMMERCIAL AIR CONDITIONERS SDV4

2. Стр. 2

   Original instructions

3. Стр. 3 CAUTION

   Put the louver horizontally when cooling. Do not disconnect the power. Do not disconnect the power. Do not disconnect the power when the unit is in operation. Please control it with the remote controller. There will be water condensing on the louvers if setting the louvers down when cooling.…

4. Стр. 5 In order to avoid electric shock or fire, make sure that an

   earth leak detector is installed. Be sure the air conditioner is grounded. In order to avoid electric shock, make sure that the unit is grounded and that the earth wire is not connected to gas or water pipe, lightning conductor or telephone earth wire. In order to avoid injury, do not remove the fan…

5. Стр. 6 ■ Wall-mounted type

   Air Intake (Intake room air here) ■ High static pressure duct type Grounding Screw (In the control box) Heat Exchanger (Exchange cool air into warm air) Air Outlet (Outlet room air) Air Outlet Horizontal Louver (Adjust the air-out directions. ) Air Filter (Filter the dust in the air) Electric…

6. Стр. 7 Indoor unit

   Low-pressure pipe Outlet pipe Connecting pipe Hi-pressure pipe Inlet pipe Throttle part Electric control box Fig.2-10 ■ Middle static pressure duct type Air Intake (Intake room air here) Electric control box Air Outlet (Outlet room air) Heat Exchanger (Exchange cool air into warm air) Fig.2-11 ■ Low…

7. Стр. 8

   AIR CONDITIONER OPERATIONS AND PERFORMANCE Use the system in the following temperature for safe and effective operation. The Max operation temperature for the air conditioner.(Cooling/Heating) Table 3-1 Temperature Mode Indoor temperature 17°C ~ 32°C Cooling operation Heating operating (cooling only…

8. Стр. 9 ● To maintain the comfortable temperature

   When using the panel with auto.louver, press SWING button , the auto, louver will swing automatically and the best cooling (heating) effects will be achieved. Adjust the air-out direction with using the air-out louver. 4. ADJUSTING AIR FLOW DIRECTION. Because cold air flow down and hot air flow…

9. Стр. 10 ■ Duct-ceiling type

   The following is how to adjust the air flow direction when the air outlet parts (sold separiN ately) is used with the indoor unit. ● When cooling To effectively heat the bottom of the room please set the louver downwards. (Fig.4-9) ● When heating To effectively heat the bottom of the room please set…

10. Стр. 11 CAUTION

    1 Water drop may be caused on the surface of the unit or horizantal louver when cooling while the air-out direction is vertically down. 2 Indoor temperature will not be even on the heating mode when the air-out direction is horizontal. 3 Do not move the horizontal louver with hands, or malfunction…

11. Стр. 12

    MAINTENANCE CAUTION 1 Before you clean the air conditioner, be sure the power supply is off. 2 Check if the wiring is not broken off or disconnected. 3 Use a dry cloth to wipe the indoor unit and remote controller. 4 A wet cloth may be used to clean the indoor unit if it is very dirty. 5 Never use a…

12. Стр. 13 2. Dismantle the air filter

    Maintenance before a long stop period 3. Clean the air filter (eg. at the end of the season) The air filter can prevent the dust or other particulate from going inside .In case of blockage of the filter , the working efficiency of the air conditioner may greatly decrease . Therefore , the filter…

13. Стр. 14

    FOLLOWING SYMPTOMS ARE NOT AIR CONDITIONER TROUBLES Symptom 1: The system does not operate The air conditioner does not start immediately after the ON/OFF button on the romote controller is pressed. If the operation lamp lights, the system is in normal condition.To prevent overloading of the…

14. Стр. 15

    7.1 TROUBLESHOOTING Troubles and causes of air conditioner If one of the following malfunctions occur, stop operation, shut off the power, and contact with your dealer. Remote controller receives malfunction or the button does not work well. A safety device such as a fuse, a breaker frequently…

15. Стр. 16

    Troubles and causes of remote controller Before asking for serving or repairing, check the following points.(See in Table 7-2) Table 7-2 Symptoms The fan speed can not be changed. Causes Solution Check whether the MODE indicated on the display is "AUTO" When the automatic mode is selected, the air…

16. Стр. 18 NOTE CONCERNING PROTECTION OF ENVIRONMENT

    This product must not be disposed of via normal household waste after its service life, but must be taken to a collection station for the recycling of electrical and electronic devices. The symbol on the product, the operating instructions or the packaging indicate such disposal procedures. The…

Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.