Инструкция на Воздушные конденсаторные теплообменники DeLonghi серии BRC, BRE, BDC, ARC

Текст инструкции

1. Стр. 1 MANUALE DI ISTRUZIONI / INSTRUCTION MANUAL

2. Стр. 2 DECLARATION OF CONFORMITY

   DECLARATION OF CONFORMITY The Company: Climaveneta Home System S.r.l. / Delonghi Group con sede Legale in Via Seitz, 47 31100 TREVISO DECLARES under its own responsibility • the EXTERNAL AIR COOLED CONDENSERS are in conformity with: • Machinery Directive 98/37/EC. • Low Voltage Directive 73/23/EC. •…

3. Стр. 4 SAFETY INSTRUCTIONS

   • READ THE INSTRUCTION MANUAL CAREFULLY BEFORE CARRYING OUT ANY WORK ON THE EQUIPMENT. • The condenser is factory precharged with dry nitrogen or with dry air to prevent the ingress of any water vapour. Before removing the plugs from the inlet and outlet connections for installation, discharge the…

4. Стр. 5 CONFIGURATION

   O - HORIZONTAL flow V - VERTICAL flow VERSION ST - Standard LT - Low temperature MAIN ACCESSORIES ACCESSORIES Support brackets for horizontal mounting (vertical air discarge) Surface treatments on custmer demand AIR FLOW CONFIGURATIONS HORIZONTAL AIR DISCHARGE ARRANGEMENT 1 Propeller fan 2 Holding…

5. Стр. 6 TRANSPORT - POSITIONING ON SITE

   SYMBOL MEANING FRAGILE: handle with care. PROTECT AGAINST MOISTURE: the packed unit must be stored in a dry place. CENTRE OF GRAVITY: shows the centre of gravity of the packed unit. KEEP AWAY FROM HEAT: the unit must be kept away from heat sources. THIS SIDE UP shows the orientation of the unit.…

6. Стр. 7 TECHNICAL DATA SHEET

   Models BRC 014m 021m 025m 030m 040m 052m 042b 051b 077b 088b 093b 102b 120b Nominal heat exchange capacity (1) kW Nominal air flow mq/h 4700 6410 8780 8410 12820 17560 12820 17560 26340 25230 23610 35120 33640 Sound pressure 10m dB(A) Nominal characteristics Fan Number Fan Diameter mm Supply voltage…

7. Стр. 8 INSTALLATION

   Position the condenser in the open air out of direct sunlight. It can be installed: • with horizontal air discharge (standard version) for best protection (from snow or from objects falling from above) and easier maintenance; in this configuration the condenser must be protected from the wind which…

8. Стр. 9 ALL VERSIONS

9. Стр. 10 PIPE SHAPE

   It is recommended that the piping, whose total length should preferably not exceed 30 metres, be installed by an expert refrigeration operator according to the following instructions (see fig.). • Where possible make straight lines; • incline the discharge line with a gradient of 1/100 in the…

10. Стр. 11 DIMENTIONS AND WEIGHTS

11. Стр. 12 MAINTENANCE

    • Regularly check the state of the condenser fins; remove from them all foreign objects (leaves, feathers, seeds, dust, etc.) using a jet of compressed air. The heat exchanger fins are made of thin aluminium sheet and can cause cuts in the event of the accidental contact • Check that the operation…

Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.