Инструкции на Напольно-потолочные кондиционеры Carrier серии 42XQ / 42XQA...

Текст инструкции

1. Стр. 1 OWNER’S MANUAL

   42XQ/XQA ® 42XQ UNDERCEILING CONSOLE 42XQA 42XQ : Cooling only direct expansion Fan Coil Unit (Wireless Control) 42XQA : Cooling only direct expansion Fan Coil Unit (Wired Control)

2. Стр. 2 Thank you for choosing Carrier!

   You can be sure that you’ve made a wise choice, because the same pride we take in manufacturing the Carrier equipment installed in the Astrodome in Texas, in the Sistine Chapel, in the Capitol – the seat of the US Congress – and in thousands of other installations worldwide, is embodied in the…

3. Стр. 4 PRECAUTIONS

   Safety considerations The installation, servicing and maintenance of air conditioning equipment may be hazardous due to the pressure which the refrigerant gas exerts on the interior, and its electrical components. Only specialized and professionally qualified personnel may install, repair or perform…

4. Стр. 5 CAUTION

   DISCONNECTING THE UNIT FROM THE MAIN POWER SUPPLY These units must be connected to the main electrical power supply through a circuit-breaker or switch fuse with an appropriate capacity and with a minimum separation between the contacts of 3mm. If this is not possible, a contact/container…

5. Стр. 6 4) Use only a circuit-breaker with a suitable

   capacity. Keep the unit away from heat sources. High temperatures may cause physical damage to the unit. 5) Do not obstruct the air discharge of any of the indoor and outdoor unit. Doing so, blocks the airflow, reducing the cooling capacity and causing the unit to malfunction. 7) In summer, prevent…

6. Стр. 7 DISPLAYS OF THE INDOOR UNIT,

   LED INDICATORS AND CONTROLS T S P R Q : EMERGENCY and RESET button : Receiver of remote control signal : Green LED : Yellow LED : Red LED NOTE Indoor Unit LEDs Information about the operating mode of the indoor unit is given by the 3 LEDs (light-emitting diodes) on the unit. THE GREEN LED (P)…

7. Стр. 8 THE RED LED (Q) indicates the following

   information • During normal operation, the LED is switched off. During defrosting, the LED is illuminated. During the testing of the electrical connections, the LED flashes at 1 second intervals. • • THE YELLOW LED (R) indicates that the unit is operating in timer mode. During this operating mode…

8. Стр. 9 REMOTE CONTROL

   The remote control works with 1.5 V batteries. When the battery icon appears on the display of the remote control, it’s time to replace the old batteries. CAUTION Before replacing the batteries, the device must be disconnected. Inserting the batteries • Open the battery compartment on the back of…

9. Стр. 10 NOTE

   • The maximum distance for the infrared remote control to work properly is 5 metres. • There must be no objects, for example, curtains, obstructing the space between the unit and the remote control. NOTE • Sunlight shinning directly onto the signal reception area of the unit may cause difficulties…

10. Стр. 11 USING THE SELECTED FUNCTIONS

    1. Operating mode (from left to right): 7. Low battery indicator • Ventilation (fan only) 8. Position of the air deflector • Cooling with dehumidification 9. Fan speed • Dehumidification only 10. Active customization 2. Signal transmission symbol 11. Timer ON selected 3. Temperature reading 12.…

11. Стр. 12 USING THE WIRELESS REMOTE CONTROL

    Connect / Disconnect (Key B) Indicated symbol Ventilation (fan only) When the air conditioner is disconnected, the control display shows only the hour of the day (if other icons are shown, disconnect the control by pressing the “ ” button). The unit only emits the BEEP acoustic signal when the…

12. Стр. 13 Selecting the airflow direction

    (Key H) Selecting the fan speed (Key E) The deflector direction must be set so as to optimize the ambient airflow distribution. The fan speed can be selected by pressing the button with the icon. Press the button until one of the following positions is displayed: Indicated symbol Icons appearing on…

13. Стр. 14

    < 2. HOUR and MINUTES buttons ( and buttons) If the unit is connected, the only possible selection is the time of starting operation. The unit operates with the selections shown on the display. < < < < < 3. HOUR and MINUTES buttons ( and buttons) If the unit is disconnected: select the operating…

14. Стр. 15 Customization

    (Button G and F) and Daily timer (DAILY - button J) If you want to save a customized operating mode which you can reactive at any time, complete the following steps: 1. With the remote control connected or disconnected, press button and keep it pressed down for more than 5 seconds. The customization…

15. Стр. 16 If you want the daily operating mode to start

    at 5:30pm and stop at 10:30pm, proceed as follows: 1. Select timer ON for 5:30pm 2. Select timer OFF for 10:30pm 3. Press the button of the daily operating mode (Button ) Programming the night timer (SLEEP - button ) Press this button to set the night timer (SLEEP) with the remote control connected.…

16. Стр. 17 Setting the hour

    (Button N) CAUTION !!! 1. With the remote control connected or disconnected, press button . The air conditioner will not work if there are curtains, doors or other objects blocking the signal sent from the remote control to the unit. < < 2. The numbers of the hour start flashing. Press button or to…

17. Стр. 18 Control to the left and right

    Specifications If you want to set the direction of the air to the right or left, adjust the deflector by hand after opening the horizontal deflector. • Operating Modes: Off (disconnected), Cool (cooling), Dry (dehumidification), and Fan only (ventilation). • Fan Speeds: Low, Medium, High and Auto. •…

18. Стр. 19 Display the selected functions

    Control Powered Up All of the segments of the Remote Control Display must be powered up for five seconds. Information about the operating mode, fan speed, desired temperature and configuration must be read from the Microprocessor inside the Remote Control. If the EEPROM values are not valid, the…

19. Стр. 20 SETTING THE OPERATING MODE

    COOL and DRY modes “MODE” button • ICON of the Operating Mode. • Ambient Temperature: if configured by canceling the temperature sensor of the ambient environment unit (operated by the environment controller); otherwise the temperature is selected by the user with the “SET TEMP” icon. • FAN/LOUVRE…

20. Стр. 21 FAN ONLY mode

    “FAN” button FAN ONLY Operation with fan ventilation only Setting the fan speed. When the “FAN” button is pressed, the fan speed is changed. To reach the desired speed, the “FAN” speed button must be pressed and then released. Low, Medium, High or Auto. (up) “UP” and “DOWN” buttons Selecting the…

21. Стр. 22 Air Deflector Control

    Information about Filters • • Air Filters (optional) - Option 1: Electrostatic Filter + Activated Carbon Filter. - Option 2 : Electrostatic Filter + Photocatalyzer Filter. • The air filters trap dust and small particles. • The optional combination Electrostatic Filter + Photocatalyzer Filter traps…

22. Стр. 23 CARE AND MAINTENANCE

    Operating Conditions Prevention of freezing in the indoor unit The temperature ranges compatible with the unit are as follows: • MODE INDOORS OUTDOORS COOLING 21~32oC 21~46oC DEHUMIDIFICATION 17~32oC 12~46oC • • When the unit is operating below or above these conditions for an extended period of…

23. Стр. 24 PRACTICAL TIPS

    Optimal comfort with low consumption • If you know that your air conditioner will not be used for an extended period of time: Ensure that you maintain the temperature of your house within the comfort zone. • • When the unit is operating in cooling mode, prevent sunlight from entering the house.…

24. Стр. 25 Cleaning the Indoor Unit

    Cleaning the outdoor Unit • Always disconnect the main power supply before unit performing any cleaning work. • From time to time, clean the area around the outdoor unit and remove the waste that may have accumulated and could cause a reduction in air circulation. • Only use a clean damp cloth and…

25. Стр. 26 PRACTICAL TIPS

    Maintenance and User Guide Cleaning washable cloth filters Cleaning the Filters To determine how often these filters should be washed, you should take 1 month of operation as the basic length of time between washings. • The cloth filters must be washed with water only. • Remove the filters. • First…

26. Стр. 27 Photocatalyzer Filters

    Installer’s Guide After finishing the installation and testing, explain the main points of this Manual to the user, giving special attention to the main operating modes of the air-conditioning equipment as stated below: • • Clean these filters once every three months. Wash them with water and leave…

27. Стр. 28 WARNING

    DO NOT SWITCH ON/OFF FROM MAIN POWER ISOLATING SWITCH OR WALL MOUNTED CONTACTOR. USE ONLY SWITCHES ON WIRELESS OR WIRED REMOTE CONTROL TO AVOID DAMAGE TO OUTDOOR COMPRESSOR. ® Carrier International Sdn. Bhd. Malaysia Carrier International Sdn. Bhd. (3385-T) Lot 4, Jalan P/6, 43650 Bandar Baru Bangi…

Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.