Инструкция на Системы воздуховодов Lindab Safe

Текст инструкции

1. Стр. 1 Mounting instruction

   Lindab Safe and Lindab Safe Click

2. Стр. 2 Type-approved ducts and fittings

   Lindab Safe and Lindab Safe Click The Lindab Safe and the Lindab Safe Click duct system are type-approved, as per certificate no. 1358/88 issued by SITAC and are subject to continuous production checks. This means that the requirements for air tightness class D are met if ducts and fittings of the…

3. Стр. 3 Preparations for assembly

   • Check that ducts and fittings to be used in the system are labelled as shown above. • Store ducts and fittings in a well-ordered and weatherproof storage area to minimize the risk of damage. Do not use ducts or fittings that have been damaged in such a way that they jeopardise the air tightness or…

4. Стр. 4 Assembly

   Lindab Safe Lindab Safe Click 1 Insert the fitting´s turned-over edge into the duct. 1 Insert the fitting´s turned-over edge into the duct. 2 Check that the gasket's first lip is in contact 2 with the duct's edge all the way around and points straight out so that the lip is not twisted in any…

5. Стр. 5 Table 3. Allowed and banned screws and blind rivets

   L Screw with sharp tip L D • Very tight • Strong since it forms a collar in the thin sheet metal Allowed by Lindab Screw with reduced drill tip • Very tight • Strong since it only drills off a small part of the thin sheet metal Allowed by Lindab d L D Screw with drill tip • Not tight • Weak since it…

6. Стр. 6 Hints!

   Turning and bending the fitting slightly as you insert it into the duct aids assembly and removal. If ducts and fittings are round, assembly is much easier. Lindab has placed high demands on roundness during the design and production stages, but large heavy fittings in particular have a tendency to…

7. Стр. 7 To lengthwise adjust joined products instead of cutting the duct

   Lindab Safe Lindab Safe Click Solution: Solution: 1 Use products with sliding property. E.g. slide-in coupling SNPU or slide-in female coupling SMFU. 2 Join together with screws or blind rivets. 1 Use products with sliding property. E.g. slidein coupling SNPU or slide-in female coupling SMFU. 2 Join…

8. Стр. 8 Dismantling

   To separate joined products. Lindab Safe Solution: Solution: 1 Unscrew the screws or drill away the blind rivets. 2 Twist the product loose. 3 The fitting will now have leaking holes but can be reused if these holes are carefully sealed off with mastic or tape. 1 Drill a 5 mm hole in the duct 4 mm…

Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.