Инструкции на Промышленные кондиционеры Sinclair серии SDV4

Текст инструкции

1. Стр. 1 FULL DC INVERTER SYSTEMS

2. Стр. 2

   Original instructions

3. Стр. 3

   Fig.1 1 2 air outlet air inlet 3 4 Fix leg Refrigerant piping connection part (connection part in side) NOTE All the pictures in this manual are for explanation purpose only. They may be slightly different from the air conditioner you purchased(depend on model). The actual shape shall prevail.…

4. Стр. 5 Do not touch the heat exchanger fins

   These fins are sharp and could result in cutting injuries. Do not place items which might be damaged by moisture under the indoor unit. Condensation may form if the humidity is above 80%, the drain outlet is blocked or the filter is polluted. After a long use, check the unit stand and fitting for…

5. Стр. 6

   Normal display Display “--” Operating mode (0—Stanby; 2—Cooling; 3—Heating; 4—Forced cooling˅ The last fault or protection code (if there is no fault or protection code it will be display “nn”) Ę Ę Ę 4.1 Protection Equipment Ę Operating fan speed grade (0—Power off) Version of the program Ę Ę The…

6. Стр. 7 4.5 Cooling and heating operation

   The indoor unit of the intelligent inverter centralized air conditioner can be controlled solely, but the indoor unit in the same system can not run cooling and heating at the same time. When the Cooling and Heating operation confront with each other, the Indoor Unit which are running on Cooling…

7. Стр. 8 Table 5-2 (SDV4-105EAA)

   Malfunction or Protection Display E2 Communication malfunction between indoor/outdoor units E4 T3&T4 temperature sensor malfunction E5 Power voltage protection E6 Fan Protection E7 Compressor discharge temperature sensor malfunction E9 EEPROM malfunction EA A fan in the Aregion run for more than 5…

8. Стр. 9

   FOLLOWING SYMPTOMS ARE NOT AIR CONDITIONER TROUBLES Symptom 4.2: Indoor unit, outdoor unit A continuous low hissing sound is heard when the system is in operation. This is the sound of refrigerant gas flowing through both indoor and outdoor units. Symptom 1: The system does not operate The air…

9. Стр. 10 Table 7-1

   Symptoms Causes Solution Unit Unit does does not not start start Power failure. Power switch is off. Fuse of power switch may have burned. Batteries of remote controller exhausted or other problem of controller. Wait for the comeback of power. Switch on the power. ReplLocation: Replace the…

10. Стр. 11 7.2 Troubles and causes of remote controller

    Before asking for serving or repairing, check the following points. (see in Table 7-2) Table 7-2 Symptoms Causes Check whether the MODE indicated on the display is "AUTO" When the automatic mode is selected, the air conditioner will automatically change the fan speed. Check whether the MODE…

11. Стр. 13 Take-back of electrical waste

    Information for Users to Disposal of electrical and electronic equipment (private households) Icon on the product or in the accompanying documentation means that used electric or electronic products must not be disposed together with domestic waste. For the correct disposal of the product hand it…

Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.