Инструкция на Контроллеры Mitsubishi Electric серии GB-50A
Центральный контроллер GB-50A для управления кондиционерами Mitsubishi Electric. Руководство пользователя.
Загружаем документ…
Текст инструкции
-
Safety Please take a moment to review these safety precautions. They are provided for your protection and to prevent damage to the controller. This safety information applies to all operators and service personnel. After you have read this manual, always observe the procedures described in the…
-
CAUTION
Do not install the controller in a place where flammable gas could leak. If gas leaks and collects around the unit, it may cause a fire or explosion. Do not wash this controller with water. It may cause an electric shock or malfunction. Do not use the controller in special environments. The…
-
Introduction 2-1. About this manual This manual covers the settings that can be made or functions that can be displayed only on the GB-50A body. 2-2. Monitor and operation of the air conditioners To monitor and operate the air conditioners, license for “GB-50A License Pack” or “Web Monitor” must be…
-
Function Notes ● Refer to the WEB Browser Operation Manual for the operation of GB-50A. ● There are two ways to make the initial settings via LAN: one is to use the initial setting web and the other is to use the initial setting tool. Either can be used to make the settings, although initial setting…
-
3-2.Function list
The use of GB-50A requires a license registration. By registering the license, group or block operation of the units on the Web browser will become available. Registration for the license that is required to use various functions can be completed on the license registration page. Table 3-2 List of…
-
3-3 Setting Functions
Make initial settings with either the Initial Setting Web or Initial Setting Tool. Table 3-3 List of initial-setting functions Initial Setting Tool Initial Setting Web √ √ √ √ The settings of the simple setting have the priority over other settings. √ √ Presence/absence of K transmission converter…
-
Notes
● When 15 or fewer GB-50A units are used in the designated network for air-conditioning, it is recommended that the IP address be set using SW2 on the unit. ● If the set IP address of GB-50A is forgotten, check the IP address that is registered on the monitoring PC (WEB or TG-2000A). GB-50A can be…
-
External input/output function *External signal input requires the external I/O adapter (Model: PAC-YG10HA) sold separately. 4-1 External input function (1) The function of external input • Emergency stop/normal operation, ON/OFF, local remote control prohibit/permit can be controlled for…
-
(A) Level signal
① When the level signal is selected, the operation (only ON/OFF operation) for the central controller and the local remote controller are prohibited (except during normal operation). ② When the emergency stop/normal operation signal is selected, the status will be changed from normal operation to…
Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.