Инструкция на Фанкойлы MDV (сервис мануалы)
Фанкойлы кассетного типа MDV серии MDKD (компактные, 4-х трубные). Сервис мануал 2014.
Смотрите также: Сервис мануал →
Загружаем документ…
Текст инструкции
-
1. Introduction
Fan coil unit is a kind of compound device which assemble fan and surface-type coil heating-exchanger together. Fan coil with fresh air supply system is a main type of center air-conditioner system, so it is an important component of AC devices. Fan coil has horizontal type, vertical type, etc. A…
-
2. Nomenclature
MD K D – 300 Nominal Air Volume (CFM) Type Code D: 4-way Cassette (compact) Chilled Water Fan Coil Unit MDV Nomenclature 3
-
3. Product Schedule
Model 4 Air volume (CFM) MDKD-300 300 MDKD-400 400 MDKD-450 450 MDKD-500 500 Power supply 220~240V-1Ph-50Hz Auxiliary Electrical Heater Without Product Schedule
-
4. External Appearance
External Appearance 5
-
5. Features
6 Capacity range: 300CFM to 500CFM Compact design, simple installation and easy maintenance Round blow air supply enables uniform air flow distribution Comfortable horizontal air discharge reduces draughts and ceiling soiling Unique design of the centrifugal fan ensures…
-
6. Specifications
Model MDKD- m /h CFM m /h CFM m /h CFM Cooling Capacity (Hi/Med/Lo) kW 3/2.58/2.16 3.7/3.18/2.66 4.1/3.3/2.83 4.5/3.6/3.06 Heating Capacity (Hi/Med/Lo) kW 4/3.5/3.08 5.1/4.3/3.83 5.6/4.5/3.9 6/4.76/4.07 Power Input W Noise (Hi/Med/Lo) dB(A) 36/33/28 42/39/32 43/40/33 45/42/34 Water Flow l/min 8.7…
-
7. Dimension
H(mm) 8 50 Dimension
-
8. Wiring Diagrams
8.1 MDKD-300 MDKD-400 Wiring Diagrams MDKD-450 9
-
8.2 MDKD-500
10 Wiring Diagrams
-
9. Capacity Tables
-
MDKD-400
-
EWT
-
MDKD-500
-
Heating Capacity
-
10. Exploded View
MDKD-300 MDKD-400 MDKD-450 MDKD-500 No. Part No. Part 1 Panel Name 1 16 Drain pump installation base 1 1.1 Display board 1 17 Water level sensor ass'y 1 1.2 Swing motor 1 18 Drain pump 1 1.3 Room temp sensor ass'y 1 19 Guard against block up net 1 2 Evaporator hang board 2 20 Drain pipe 1 3 Wire…
-
11. Installation
11.1 Installation space The indoor unit should be installed in a location that meets the following requirements: There is enough room for installation and maintenance. The ceiling is horizontal, and its structure can endure the weight of the indoor unit. The outlet and the inlet are not…
-
B. New built houses and ceilings
a. In the case of new built house, the hook can be embedded in advance (refer to the A.b mentioned above). But it should be strong enough to bear the indoor unit and will not become loose because of concrete shrinking. b. After installing the body, please fasten the installation paper board onto the…
-
b
Draw the grid up to an angle of about 45o, and remove it. (2) Remove the installation covers at the four corners. Wrench off the bolts, loose the rope of the installation covers, and remove them. (3) Install the panel a. Align the swing motor on the panel to the tubing joints of the body properly.…
-
MCAC-KTSM-2012-02
at local market or from your dealer. Set the mouth of the drainpipe onto the root of the body's pump-pipe, and clip the drainpipe and the out-let pipe sheath (fittings) together firmly with the out-let pipe clasp (fitting). Cautions: Use your strength carefully to prevent the pump-pipe from…
-
Cautions
All the joints of the drain system must be sealed to prevent water leakage. 1. All field piping must be provided by a licensed water technician and must comply with the relevant local and national codes. 2. Do not let air, dust, or other impurities fall in the pipe system during the time of…
-
MCAC-KTSM-2012-02
3. The wiring work should be done by qualified persons according to circuit drawing. 4. An all-pole disconnection switch having a contract separation of at least 3mm in a pole should be connected in fixed wiring. 5. Be sure to locate the power wiring and the signal wiring well to avoid…
-
Installation
-
11.5 Test operation
(1) The test operation must be carried out after the entire installation has been completed. (2) Please confirm the following points before the test operation. The indoor unit and outdoor unit are installed properly. Tubing and wiring are correctly completed. The refrigerant pipe system is…
Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.