Инструкция на Контроллеры Hitachi серии PC-LH3A

Текст инструкции

1. Стр. 1

   FUNCIONAMENTO BRUGER- OG MONTERINGSVEJLEDNING INSTALLATIE- EN BEDIENINGSHANDLEIDING HANDBOK FÖR INSTALLATION OCH ANVÄNDING ÅÃ×ÅÉÑÉÄÉÏÅÃÊÁÔÁÓÔÁÓÇÓÊÁÉËÅÉÔÏÕÑÃÉÁÓ ENGLISH SVENSKA Do not perform installation work, without referring to our installation manual. No realice la instalación de este equipo…

2. Стр. 3 – Hazards or unsafe practices which COULD result in minor personal injury or

   CAUTION product or property damage. PRECAUCIÓN – Riesgos o prácticas poco seguras que PODRÍAN provocar lesiones personales de menor importancia o daños en el producto u otros bienes. VORSICHT – Gefährliche oder unsichere Anwendung, die geringfügigen Personen-, Produkt- oder Sachschaden verursachen…

3. Стр. 5

   SAFETY SUMMARY Õ DANGER: DO NOT pour water into the remote control switch (hereafter called "controller"). This product is equipped with electrical parts. If poured, it will cause a serious electrical shock. Ô WARNING: DO NOT perform installation work and electrical wiring connection by yourself.…

4. Стр. 6

   4 NAME OF PARTS „ Controller This controller is used to send commands about operation mode, timer setting, etc. to the indoor unit. Face the transmitter of the controller toward the receiver of the indoor unit and press the switch of required operation so that commands (by infrared rays) are sent to…

5. Стр. 7

   SENDING COMMANDS FROM CONTROLLER „ The operation commands are sent by pressing the required operation switch by facing the transmitter of the controller toward the receiver of the indoor unit. 1 When the commands are sent, the ' ' indication on the liquid crystal display of the controller flashes…

6. Стр. 8

   6 OPERATION „ When operating the controller, face the transmitter toward the receiver of the indoor unit and press the switch for the required operation as described in the item '4. Sending Commands from Controller'. Ô ATTENTION: In case that two indoor units are installed side by side, the commands…

7. Стр. 9

   TEST RUNNING BY CONTROLLER Ô ATTENTION: Test running by the controller can not be performed in case that the wired remote control switch is used together; in case that multiple units are operated simultaneously (SET-FREE and UTOPIA Series). In such cases, perform the test running by the wired remote…

8. Стр. 10

   9 SIMULTANEOUS OPERATION OF MULTIPLE INDOOR UNITS The multiple indoor units (Max. 16 units) can be started and stopped simultaneously by one controller. Perform this operation only in case that multiple indoor units are installed in a room as shown in the figure. CAUTION: Do not perform this…

9. Стр. 11 4) Set the rotary switches (RSW) on the printed circuit boards in the electrical box of each indoor

   unit as shown in the figure below. No. 0 Unit No. 1 Unit No. 2 Unit No. 3 Unit No. 4 Unit No. 5 Unit No. 6 Unit No. 7 Unit No. 8 Unit No. 9 Unit No. 10 Unit No. 11 Unit No. 12 Unit No. 13 Unit No. 14 Unit No. 15 Unit Rotary switch Setting Rotary switch Setting Ô ATTENTION: In case that the setting…

Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.