Инструкция на Мультсплит-системы коммерческого назначения General серии Big Multi AJGA90E(T)ATB
Наружные блоки мультсплит-системы коммерческого назначения General серии Big Multi AJGA90E(T)ATB. Инструкция по монтажу.
Загружаем документ…
Текст инструкции
-
CAUTION!
• Be careful not to scratch the air conditioner when handling it. • After installation, explain correct operation to the customer, using the operating manual. • Let the customer keep this installation instruction sheet because it is used when the air conditioner is serviced or moved. • The maximum…
-
Front side
Fig. 2 10 mm or more 500 mm or more 10 mm or more • Installing the unit individually 300 mm or more (1) If possible, do not install the unit where it will be exposed to direct sunlight. (If necessary, install a blind that does not interfere with the air flow.) (2) Install the outdoor unit in a place…
-
Fig. 6
Knockout hole Drain pan Drain pipe Drain pipe mounting holes Rear panel Hose Rear panel (2) Drain Processing (Reverse cycle model only) • Remove the rear panel. minimize shock and vibration. • Do not set the unit directly on the ground because it will cause problems. • Set the unit on a strong…
-
Width across flats
width across flats 24 mm 1.9 to 2.2 mm L dimension OK Extend the pipe by unwinding it. NO Do not bend the pipes in an angle more than 90°. When pipes are repeatedly bent or stretched, the material will harden, making it difficult to bend or stretch them any more. Do not bend or stretch the pipes…
-
$A@0;;>
A:5@?501 :0;;> A:5@ ?501 ;::1/@5;:<5<1 >-F5:3 -88->;A:0 ;::1/@5;: %5<1 :0;;>/-<588->E@A.1 5:/8A010C5@45:0;;>A:5@ >-F5:3 -88->;A:0 (-<1 31 ;::1/@5;:<5<1 31 (-<1 ;:@5:A10;:.-/7 >-:/485=A50<5<1 :0;;> /-<588->E@A.1 &?411@ 5:/8A010C5@45:0;;>A:5@ ;:;@-@@-/4@415:0;;>/-<588->E@A.1@;9;018…
-
Table 8
Cap 250 to 300 kgf • cm (49 to 53.9 N • m) Close Open Close Hexagon wrench Open Spindle 250 to 300 kgf • cm (25.4 to 29.4 N • m) 180 to 210 kgf • cm (18.0 to 20.5 N • m) Valve Cap Fig. 27 Gas valve Liquid valve 60 to 80 kgf • cm (6.0 to 8.0 N • m) Spindle (1) Remove the cap, and connect the gauge…
-
Insulation tube
Insulation tube Cord clamp Control box metal cover Fig. 31 (2) Remove control box metal cover and connect the power supply cord and the outdoor unit connection cord wire at the indoor unit. Front panel right Control box metal cover Fig. 30 (1) Remove the front panel right. Use VW-1, 0.5 to 1.0 mm…
-
ALL LEDs
LED 6 LED 5 LED 4 LED 3 LED 2 LED 1 LED LED DISPLAY 0.5 sec./0.5 sec. flashing 3 times Discharge temperature thermistor B faulty 0.1 sec./0.1 sec. flashing Lighted continuously 0.5 sec./0.5 sec. flashing once 0.5 sec./0.5 sec. flashing 2 times 0.5 sec./0.5 sec. flashing 3 times 0.5 sec./0.5 sec.…
Схемы, таблицы и рисунки — в просмотре документа выше. Клик по номеру страницы открывает её в просмотре.